Audio over IP
Using Dante Virtual Soundcard With The Logitek JET67 and NET67
Here are the steps for using Dante Virtual Soundcard with the Logitek JET67 Audio Engine and NET67 card for JetStream Plus. On the JET67 Audio Engine, the optional J67-DANTE module must be installed. On the NET67 card for JetStream Plus, a Dante ...
Using the Livewire+ AoIP driver with the JET67 and NET67
Follow this guide to configure the Livewire+ AES-67 driver for use with the Logitek JET67 Audio Engine. Open Livewire driver GUI. In the Sources list check the Enable box, enter the stream name, Livewire channel number and packet mode. Press the ...
How To Manually Add AoIP Streams To The JET67 and NET67
The JET67 Audio Engine and the NET67 card for the Logitek JetStream Plus uses SAP to announce streams to other Livewire and AES67 devices and receive stream announcements from those other Livewire and AES-67 devices. Some Livewire devices send and ...
Dante Virtual Soundcard/Dante Controller Latency Issues with Dell PCs
A customer reports: "We’ve been experiencing an issue with the machine that the Ovation audio sequencer runs on. Basically, we’ve been seeing Dante controller reporting large latency hits as seen by Logitek. Initially it was only Logitek, but that’s ...
Choosing An IP Address Scheme for Logitek AoIP
Set up a private IP address range that doesn't conflict with other subnets in your network, and keep your Audio over IP devices in that range. We don't have a preference, just pick something that works for your facility. Not to get too deep in the ...
How To Set Up Merging Technologies Ovation with JetNet WDM Driver/JetStream Plus
For customers using the NETB audio networking card in their JetStream Mini/JetStream Plus Follow these steps to use ASIO4all to let the PC see our WDM driver as an ASIO device: Install the JetNet driver on the Ovation computer and set up the stream ...
How To Set Up Cisco Catalyst 2960 for Logitek AoIP
OverviewLogitek uses multicast audio packets to stream audio between devices. These packets require a switch with IGMP Snooping and an IGMP Querier for proper management. You must set up these features in order for the switch to properly take care of ...
How To Set Up HP ProCurve 2920 for Logitek AoIP
OverviewIt is critical that you enable IGMP Snooping and the IGMP Querier on your Ethernet switch for audio networking. These switch features properly manage the multicast audio packets that flow between devices. Without these features being turned ...
How To Set Up Dante On The JetStream Plus
General Notes Connect Audio Net 1 on the JSP-DSP card to the Dante Network The default out of the box is that the Dante networking module is expecting to be issued an IP address by a DHCP server. All Dante devices need to be on the same subnet. If ...
How To Set Up Cisco SG350 Series Switches for Logitek Audio over IP
Before You Begin Ensure that you have a Cisco SG350-series switch. This article only applies to Cisco SG350-series switches. Decide how IP Addresses will be managed. We strongly recommend using DHCP to assign addresses to your networked audio ...
Recommended Ethernet Switches for AoIP
Generally speaking, any Gigabit switch will work for Dante, and any Gigabit switch that supports IGMP Snooping and an IGMP Querier will work for multicast (AES-67). We have begun to recommend the Cisco SG350 series of switches. They're managed ...